Share us:
Please note that if the returned items are not in the original condition, or show some signs of usage, this includes removing or damaging the casing and protective sleeve, you will not be entitled to a refund. Similarly, in case of returning the products after long usage, that goes beyond the testing of the properties and functionality, you will not get the full refund.
Two devices are always sold, one for the OBD2 connection and the second is the kilometerfilter.
The component behind the speedometer must remain permanently installed in the car. If the module is removed and the speedometer is then reconnected to the original connector, the speedometer synchronizes with the ABS, which restores the reset kilometers. It is advisable to solder the circuit board of the super kilometer filter into the wiring harness to the speedometer to prevent unintentional removal. Observe all relevant safety and legal regulations. And the vehicle manufacturer’s installation and warranty instructions must be observed.
Before installation, the battery should be disconnected and some preparation is required. Both devices must be installed in the OBD2 connection and behind the speedometer.
The plug-and-play version is only available for the kilometer blocker and is easy to install, but must remain permanently in the car. The module for the OBD2 port must be soldered there is no other option.
The installation is very complicated and requires experience with car electronics and special tools. Beginners could damage the car.
Pull the high beam lever 5 times
The hazard warning lights flash briefly according to the currently selected mode: Mode 1 = 1x flashing, Mode 2 = 2x flashing.
Repeat the same process to switch from mode to mode.
These devices must be permanently installed in the vehicle (preferably soldered into the wiring harness) and cannot be removed after use.
Mode 1
0% of the actual mileage is recorded
Mode 2
100% of the actual mileage is recorded
Deactivate the module forever
Attention, this cannot be undone. Completely off, after which you can never switch the device on again.
Nissan Rogue Kilometer Stopper tool always keeps previously applied settings. For that reason, you don’t have to change the settings before starting a car next time.
The device can be activated or deactivated, either while in motion or when stationary.
The Kilometer Stopper is only for testing and tuning purposes and should not be used on public roads. Unlike the speedometer calibration tools, our module is not intended for fraudulent purposes.
| Weight | 100 g |
|---|
Here you will find all the details about our company
Here you will find shipping and return related information
Here you will find information on all technical questions
Here you will find helpful information about installation
Reviews
There are no reviews yet.